Habe gestern mal eine Mail an V&H geschrieben, heute morgen bekomme ich die Antwort.
Jetzt verstehe ich nicht mehr:


This Fuelpak has not yet been used to flash your bike. You need to go to 'map lookup' while connected and flash the base map for your exhaust system. Once that's done, run the map for 2-3 tanks of fuel before considering Autotune. 



AUTOTUNE INSTRUCTIONS (only use if needed after 1-2 tanks of fuel with Base Map)

**Be advised that while Autotune is active the bike will not perform optimally. The AFR table is not optimized, and the cranking fuel/accel enrichment are turned off. This may translate into poor cold start performance, erratic idle, poor throttle response, and general ride quality issues. These will resolve once you ‘Finish’ the Autotune. Letting the bike fully warmup before riding while Autotune is active will help to slightly diminish some of these symptoms. 


1) Go to the Autotune tab in the main menu of the app.


2) a  base map from which to start ( whichever slot your correct map is in, most likely slot 1 if this is a brand new FP3.


3) ‘Quick Setup'


4) It will have you flash the bike to run Autotune, follow the in app instructions (i.e. bike off for 30 seconds, etc.)


5) Once Autotune is active, you'll want to break it down into 3 sessions, approx. 20-30 minutes each.


6) After your first 20-30 minute session, open the app and go into the Autotune section. 'Apply Learned Values' and 'Apply'. This will take the data learned and store it, allowing for more data to be collected.


7) After the second 20-30 minute session do the same thing - ‘Apply Learned Values’ and then ‘Apply'. 


After the 3rd total session, 'Apply Learned Values’ and then 'Finish'. This will complete the Autotune, taking everything learned from each 'Apply' and will build the map/put it into a new slot. 
 

Sorry, hätte ich dazu schreiben müssen.
Die Autotune-Fahrt habe ich schon längst gemacht.
Ich wollte, dass V&H die Autotune-Map sich mal anschaut....

Klar, fahre schon seit Wochen mit der Autotune map.

Ja, wie gesagt ... am besten dem Support antworten und genau erklären, wie Du bislang vorgegangen bist.

Ich wollte V&H mal über meine Autotune Map schauen lassen, ob hier noch etwas verbessert werden kann!

Ich denke da antwortet ein Computer 

Ich würde sagen - Dekompressionventile on/off
 

Hat Du Dekompressionsventile - vermutlich nicht - dann Off!